Slavepost

I have build myself a 'Slave post', where I'm 'held in place', with no possibility to 'run away'.

The logic lies not so much in the 'cock'n'ball-contraption, as in the shoes. They are screwed to the 'bottom', which in effect hold my feet, when they are laced, in a manner which keeps me there - since I cannot reach them, in order to untie the shoes..!

Here you see some of the screws, holding the shoes 'in place'.

Here you have close-ups of the cock'n'ball-contraption, as well as the stop-bracket, which limit the possibilities of getting a 'full erection'.
Note the padlocks, which lock the stop-bracket, as well as the ball sack bracket in a manner, which prevent opening them without the key.

-and here you have the slave post 'empty'.

What is it made from?

1. The 'saddle' is made from a piece of 9 mm  thick plywood. ( 5/16")
2. The two U-bolts are from Silvan (my local hardware store), and measure 32 mm and 45 mm. ( 1 1/4" and 1 1/3").
3. The cock-strapping is made with a (long) shoelace.
4. The ball-sack-U-bolt is mounted on a furniture-bracket, from Silvan, with a (shortened) 6 mm bolt. (1/4").
5. The lockable wing nuts ar purchased at Silvan, and have had a hole drilled in either 'wing', after which I've added a chain-link to either 'wing'.
6. The saddle post is purchased at my local bicycle store, and has been shortened, in order to make it possible to screw it on to the 'post', with a long screw, and a washer at the top. (This in order to allow other saddles to be fitted to the slavepost).
7. The post (slavepost) itself is made from a 33 by 33 mm fir stick, from Silvan. (1 5/16 by 1 5/16")
8. The bottom plate is a piece of 22 mm thick chipboard, which I had in the basement. (7/8" thick).
9. The shoes are a pair of "Nike Air" (app. size 9½).